Table of Contents
Advertisement
IES-2000/3000 User's Guide
Procedure to Connect to MDFs
Acquire two additional MDFs (MDF 2 and 3).
Step 1.
Follow the pin assignments shown in the Pin Assignments Appendix to wire Telco-50 connectors to
Step 2.
Telco-50 cables.
Connect the Telco-50 connector end of the cable you want for DSL service to the Telco-50 connector
Step 3.
labeled USER on the splitter chassis rear panel.
Connect the wiring on the other side of the Telco-50 cable to the upper ports of MDF 3 using a punch-
Step 4.
down tool.
3-14
Table 3-19 Installation Scenario B
Hardware Overview
Advertisement
Table of Contents
Troubleshooting
