Front Audio
The front audio connector (J4) on the Karajan audio module allows
you to connect to the line-out and mic-in jacks that are at the front
panel of your system. Using this connector will disable the rear au-
dio's line-out and mic-in functions.
1
Audio
codec
Remove the jumper caps from pins 5-6 and pins 9-10 of J4 prior to
connecting the front audio cable connector. Make sure pin 1 of the
cable connector is aligned with pin 1 of J4. If you are not using this
connector, make sure to replace the jumper caps back to their
original pin locations.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
BIOS Setting
Configure the onboard audio in the Integrated Peripherals submenu
("South OnChip PCI Device" section) of the BIOS. Refer to chapter
3 for more information.
Driver Installation
Install the audio driver. Refer to chapter 4 for more information.
Hardware Installation
1
9
1 0
Line-in
Front R/L
Mic-in
Center/Subwoofer
Rear R/L
Side R/L
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
2
1
2
53