DFI LANParty UT ICFX3200-T2R/G User Manual page 54

2
Hardware Installation
IEEE 1394 Ports
1394-1
1 0
2
1394-2
9
1
The system board is equipped with an onboard IEEE 1394 port at
location CN3 (IEEE 1394-1) of the system board.
It is also equipped with an IEEE 1394 connector at location J8
(1394-2) for connecting an additional 1394 device. The 1394 port
may come mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis then
insert the connector that is attached to the 1394 port cable to J8.
Make sure pin 1 of the cable connector is aligned with pin 1 of the
J8.
BIOS Setting
Configure the onboard IEEE 1394 in the Integrated Peripherals
submenu ("South OnChip PCI Device" section) of the BIOS. Refer
to chapter 3 for more information.
54