DFI LANParty UT ICFX3200-T2R/G User Manual page 69

The FDD-type power connectors are additional power connector.s If
you are using more than one graphics cards, we recommend that
you plug a power cable from your power supply unit onto the
5V/12V power connectors at locations J1 and/or J15. This will pro-
vide more stability to the entire system. The system board will still
work even if the additional power connector is not connected.
1
+5V +12V
Ground
Ground
The system board requires a minimum of 300 Watt power supply
to operate. Your system configuration (CPU power, amount of
memory, add-in cards, peripherals, etc.) may exceed the minimum
power requirement. To ensure that adequate power is provided, we
strongly recommend that you use a minimum of 400 Watt (or
greater) power supply.
Important:
Insufficient power supplied to the system may result in instabil-
ity or the add-in boards and peripherals not functioning prop-
erly. Calculating the system's approximate power usage is im-
portant to ensure that the power supply meets the system's
consumption requirements.
J1
4
J15
Hardware Installation
2
69