DFI LANParty UT ICFX3200-T2R/G User Manual page 163

Step 3: Configure RAID in the RAID BIOS
Configure RAID in the ATI RAID BIOS
When the system powers-up and all drives have been detected, the
ATI BIOS status message screen will appear. Press the <F4> key to
enter the utility. The utility allows you to build a RAID system on
Serial ATA drives.
Configure RAID in the Promise RAID BIOS
After you power up the system and all hard disk drives have been
detected, the Promise BIOS status message screen will appear. Press
the <Ctrl> and <F> keys simultaneously to enter the utility. The
utility allows you to build a RAID system on Serial ATA drives.
Step 4: Install the RAID Driver
If you are in the process of installing Windows
2000 on RAID configured drives, you will need the provided RAID
driver floppy diskette. If you are installing the driver on existing
®
Windows XP or Windows
driver that is in the provided CD.
Installing RAID Driver While in the Process of Installing Win-
®
dows XP or Windows
The steps below will instruct you on installing the RAID driver while
in the process of installing Windows
RAID configured drives.
1. Start Windows Setup by booting from the installation CD.
2. Press <F6> when prompted at the beginning of Windows setup.
3. Now the following steps are extremely crucial because there is
an essential file that must be installed here. Press <S> to select
"Specify Additional Device".
4. At this point you will be prompted to insert a floppy disk con-
taining the RAID driver. Insert the provided RAID driver diskette.
®
2000, install the corresponding RAID
®
2000
®
XP or Windows
RAID
® ®
XP or Windows
®
2000 on
5
163