DFI LANParty UT ICFX3200-T2R/G User Manual page 49

S/PDIF-in/out Jacks
S/PDIF-in
S/PDIF-out
+5V
Key
SPDIF out
GND
SPDIF in
Optical
S/PDIF
The system board is equipped with an onboard S/PDIF-in RCA jack
(red) and a S/PDIF-out RCA jack (yellow) at locations CN5 and
CN7 respectively.
The S/PDIF connector at location J3 is used to connect optical
S/PDIF por ts. The S/PDIF ports may be mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable connector to J3.
Make sure pin 1 of the audio cable connector is aligned with pin 1
of J3.
Important:
DO NOT use optical S/PDIF and coaxial RCA S/PDIF at the
same time.
Jumper Setting
Use JP52 to select the controller that will send signal to the S/PDIF-
out port. Refer to "S/PDIF-out Settings" in this chapter for more
information.
1
5
Hardware Installation
2
49