DFI LANParty UT ICFX3200-T2R/G User Manual page 99

Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port
Auto The system will automatically select an I/O address for
the onboard serial port.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
select an I/O address for the onboard serial port.
Disabled Disables the onboard serial port.
PWRON After PWR-Fail
Off
On
Former-Sts
CIR Port Address
This field is used to select an I/O address for the CIR device.
CIR Port IRQ
This field is used to select an IRQ for the CIR device.
When power returns after an AC power failure, the
system's power is off. You must press the Power but-
ton to power-on the system.
When power returns after an AC power failure, the
system will automatically power-on.
When power returns after an AC power failure, the
system will return to the state where you left off
before power failure occurs. If the system's power is
off when AC power failure occurs, it will remain off
when power returns. If the system's power is on
when AC power failure occurs, the system will
power-on when power returns.
BIOS Setup
Allows you to manually
3
9 9