DFI LANParty UT ICFX3200-T2R/G User Manual page 106

Dfi lanparty ut icfx3200-t2r/g; lanparty ut icfx3200-t2/g system board
Table of Contents

Advertisement

3
BIOS Setup
MODEM Use IRQ
This field is used to set an IRQ channel for the modem installed in
your system.
Soft-Off by PWRBTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec.
Instant-Off
Poweron By PCI Card
Enabled
Disabled
106
Regardless of whether the Power Management
function is enabled or disabled, if the power but-
ton is pushed and released in less than 4 sec, the
system enters the Suspend mode. The purpose
of this function is to prevent the system from
powering off in case you accidentally "hit" or
pushed the power button. Push and release again
in less than 4 sec to restore. Pushing the power
button for more than 4 seconds will power off
the system.
Pressing and then releasing the power button at
once will immediately power off your system.
This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the
PCI PME (Power Management Event) signal to
remotely wake up the system.
card or PCI card will cause the system to wake up.
Refer to the card's documentation for more
information.
The system will not wake up despite access to the
PCI card.
Access to the LAN

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lanparty ut icfx3200-t2/g

Table of Contents