Resetting The Ap To Factory Defaults; Running Diagnostics - Ruckus Wireless ZoneFlex series User Manual

Resetting the AP to Factory Defaults

You can use the web interface to restore an AP to its factory default settings, which
completely erases the configuration currently active in the device.
CAUTION! DO NOT reset the AP to factory defaults unless you are directed to do so
by Ruckus Wireless support staff or by a network administrator. Do this only if you are
able to immediately reconnect the restored AP to your computer, to reconfigure it for
Wi-Fi network use — as detailed in
1. Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page
appears.
2. Click Reset now next to Reset to factory settings.
3. When the confirmation warning appears, read the message and click OK if you are
certain that you want to restore the AP to factory defaults.
After a brief pause, you are automatically logged out of the AP. You must now disconnect
the AP from the switch (and the network) and reconnect it to your computer, as described
in Step 1: Preconfiguring the AP
settings, then replace it in your site for full network use.

Running Diagnostics

Two network connection diagnostic tools – ping and traceroute – have been built into
the AP to help you check network connections from the web interface.
1. Go to Administration > Diagnostics. The Administration > Diagnostics page
appears. Two options are available:
• Ping
• Traceroute
2. Click the text field by the option you want to activate, and type the network address
of a site.
3. Click Run Test.
The results appear in the text field below each option.
ZoneFlex Indoor Access Point Release 104.0 User Guide
Installation on page 72.
on page 74. At this time, you can restore the network
Administration
Resetting the AP to Factory Defaults
145