Travel System - Britax Stroller Click & Go™Adaptor - Britax UNITY Instructions For Installation And Use Manual

TRAVEL SYSTEM -
BRITAX STROLLER CLICK & GO™ADAPTOR
TO FIT INFANT CARRIER INTO STROLLER - BRITAX
STROLLER CLICK & GO™ADAPTOR METHOD
If the Infant Carrier is fitted with Britax Stroller Click & Go™Adaptor, then fit as
follows:
IMPORTANT :
A. Where applicable, remove the stroller seat or
bassinet from the stroller frame (refer to stroller
instructions). With the Infant Carrier handle in
the "carry position"
Stroller Adaptor on each side directly over the
stroller frame mouldings and push down.
B. To secure the Carrier to the stroller rotate the
handle to the third position the "non-rocking
position" , To do this:
3
a. Squeeze the carry handle release latch on each side
of the handle and rotate to the first position-"rocking
position" 2 .
b. Squeeze the latch again and start to rotate the handle
then remove both hands from the latches and use
one hand at the top of the handle to rotate down
further until the handle latches in the second or
"non-rocking position"
to the stroller.
* Refer to page 13 for handle position
48
Only use Infant Carrier with compatible Britax/Steelcraft Stroller.
, place the Click & Go™
1
. The carrier is now locked
3
A
a
b
C
3