Britax UNITY Instructions For Installation And Use Manual page 25

INSTALLING UPPER ANCHORAGE STRAP
A. Locate the child restraint anchor fitting
in the car that is directly behind the
seat location in the rear seat you have
chosen. Refer to the car owner's
manual for the location (If there is no
anchorage fitting then refer to pages
53 - 57 for instructions in adding
an anchor fitting). Connect the Upper
Anchorage Strap Attachment Clip to the
Anchor Fitting.
Lengthen the strap by pressing the
adjuster button (1) and pull the strap (2)
so that the strap is ready to attach to the
Carrier.
THIS UPPER ANCHORAGE STRAP MUST
ALWAYS BE FITTED WHEN THE INFANT
CARRIER IS USED IN THE CAR.
B. While the Infant Carrier is out of the car, store the upper anchorage strap between
the stabilising bar and the car seat back so that it will be ready for use when the
Infant Carrier is put back in the car.
Always attach hook and remove slack.
HOW TO INSTALL
Attachment Clip
Car's Anchor Fitting
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
2
25