Britax UNITY Instructions For Installation And Use Manual page 16

HOW TO SET-UP
SETTING UP THE HARNESS
The Infant Carrier is fitted with three shoulder strap positions. As the baby grows the
shoulder straps must be moved to higher slots. Refer to page 17 - 20 for correct
fitment of the harness shoulder straps.
A. Sit the Infant Carrier on a flat ground
with the handle rotated fully back to
prevent rocking.
B. Release the buckle and lengthen the
Harness Straps by pressing Harness
Adjuster (under the flap) while grasping
both Shoulder Harness Straps and
pulling out desired amount of slack.
C. Move the two harness tongues to
the sides of the infant carrier and
store in the Buckle Tongue Holder
(if fitted) (holders are on both sides
of the Padded Insert or the sides of
the cover). Move the harness buckle
towards the Harness Adjuster.
D. Place baby into Infant Carrier lying on
its back so that the buckle is between
the baby's legs.
E. This section covers the setting up
of the harness to fit the height of the
child and fitting of the harness is
not required. Securing of the child is
covered later in the instructions.
16
Lift the Harness
Adjuster and
pull the Harness
Straps to
slacken.
Buckle Tongue
Holder (if fitted)