Infitec Wheel Assembly; Description Of The Infitec Wheel Assembly; Removing The Infitec Wheel Assembly - Barco Galaxy NH-12 Service Manual

8.4 Infitec wheel assembly
Overview
• Description of the Infitec wheel assembly
• Removing the Infitec wheel assembly
• Installing the Infitec wheel assembly
8.4.1 Description of the Infitec wheel assembly
Description
To generate active Infitec stereoscopic images, the optional Infitec wheel can be used. Only one projector is needed, since the
Infitec wheel consists out of two Infitec filters: one filter for the left image and an other for the right image.
The Infitec filter can be moved into the light path or it can be moved out through the OSD.
When the Infitec wheel is not rotating, it can not be moved in to the light path.
When the Infitec wheel is positioned in the light path and it stops rotating, it automatically will be moved out.
8.4.2 Removing the Infitec wheel assembly
Necessary tools
• Torx screwdriver T10
• Nut spanner 5.5 mm
How to remove the Infitec wheel assembly?
1. Remove the rear cover (see concerning chapter)
2. Disconnect the Infitec filter wheel assembly from the engine controller:
- connector J1: Infitec sensor
- connector J2: Infitec slide motor
- connector J7: Infitec switch
- connector J10: power
3. Release the spacer bolt one single turn
Note: Do not remove the spacer bolt completely: it is not needed and the spacer would fall off!
Image 8-15
Infitec filter wheel assembly: spacer bolt
4. Remove the fixing screw, while holding the Infitec filter wheel assembly
R59770141 GALAXY NH-12 20/02/2008
8. Optical parts and servicing procedures
123