Barco Galaxy NH-12 Service Manual page 95

Image 7-113
Preformatter unit: fixing screws
3. Lift the preformatter unit a bit and unplug the following connectors:
- J100, J101, J102 on the preformatter: data from the PMP
- J11on the preformatter: power supply from the power box
- J410 on the PMP: commands from the local keypad
- J13 on the PMP: commands from the IR receiver
4. Remove the screw fixing the three grounding wires
5. Flip over the preformatter unit
6. Remove both fixing nuts
Image 7-114
LVDS interface: fixing nuts
Note: In this picture the input module has been removed but this is not needed to remove the LVDS interface.
7. Remove the LVDS interface by unplugging the board-to-board connector
Image 7-115
LVDS interface: removing
Note: In this picture the input module has been removed but this is not needed to remove the LVDS interface.
8. Unplug the connectors:
R59770141 GALAXY NH-12 20/02/2008
7. Electronic parts and servicing procedures
91