Barco Galaxy NH-12 Service Manual page 76

7. Electronic parts and servicing procedures
Image 7-71
Input module: fixing screws chassis
3. Fix the front plate of the input module using two screws
Image 7-72
Input module: fixing screws front
4. Put the preformatter unit next to its correct position and plug in the connectors:
- J100, J101, J102 on the preformatter: data from connectors J823, J824 and J825 on the PMP
- J11on the preformatter: power supply from connector 6 on the power box
- J410 on the PMP: commands from connector J410 on the local keypad
- J13 on the PMP: commands from the IR receiver
5. Use one screw to fix the three grounding wires to the preformatter
6. Fix the preformatter unit to the input module using four screws
Image 7-73
Preformatter unit: fixing screws
7. Install the covers (see concerning chapters):
- engine fan cover 1
- top cover
- rear cover
72 R59770141 GALAXY NH-12 20/02/2008