8. Optical parts and servicing procedures
8.2
Lamp
W
ARNING
these procedures! Never remove any cover while the projector is on.
W
ARNING
C
AUTION
output of the lamp.
If the front glass cover of the lamp has been touched, finger prints can be wiped off using alcohol.
Overview
•
Lamp description
•
Removing the lamp
•
Installing the lamp
8.2.1
Lamp description
Description
The lamp is a 2 kW Xenon lamp. A lamp that has reached its end of life, can be refurbished a number of times. This implicates that
the housing is partly reused a few times, while the bulb will be replaced each time. The content of the flash memory is also updated
during refurbishment..
Picture
Image 8-2
Lamp (Xenon lamp)
8.2.2
Removing the lamp
Necessary tools
Slotted screwdriver 4 mm or 6 mm
118
:
Electrical shock hazard! Make sure to switch off and unplug the projector before starting any of
:
Burn hazard! Before removing any cover, respect the cooling time of the projector and its lamp!
:
Do not touch the front glass cover of the lamp with your fingers, since this will reduce the lamp
R59770141 GALAXY NH-12 20/02/2008