Barco Galaxy NH-12 Service Manual page 63

7. Electronic parts and servicing procedures
Image 7-45
Lamp info receiver: fixing nuts and spacers
Caution: Tighten both fixing nuts and then release them half a turn. In this way the lamp info receiver can still move slightly.
12.Install the guiding pin plate and fix it using two screws
Image 7-46
Lamp info receiver: guiding pin plate fixing screws
13.Put the lamp info receiver assembly in its correct position
14.Fix the lamp info receiver assembly to the bottom of the projector using two screws
Image 7-47
Lamp info receiver: fixing screws
15.Plug in the connector
16.Install the lamp (see concerning chapter)
17.Install the rear cover (see concerning chapter)
R59770141 GALAXY NH-12 20/02/2008 59