Contour Seat (Optional); Fig. 29 Contour Seat - Otto Bock C2000 Instructions For Use Manual

Operation
Removing the Recaro® Seat from the Chassis
1. Pull the release strap on the right and left side beneath
the seat bottom to the front. In this way, you loosen the
right and left bolt that serve to lock the seat to the frame.
2. To release the posterior seat adapter from the retainer
bushings, slightly tilt the seat to the rear and slide back a
little.
3. Remove the Recaro® seat.
Attaching the Recaro® Seat to the Chassis
CAUTION
Risk of injury if the locking bolts are not engaged. Beim
When mounting the Recaro® seat, the seat adapter must
be securely attached to the retainer bushings. The anterior
locking bolts must have snapped into place up to the key
ring.
Place the posterior edge of the Recaro® seat on the end of
the seat frame.
1. Slide the seat forward until the posterior seat adapter
hangs in the retainer bushings.
2. Tilt the seat to the front until the locking bolts engage with
the seat frame up to the key ring.
Page 156
6.7.5 Contour Seat (Optional)
The C2000 power wheelchair can be equipped with a contour
seat of different sizes. This results in greater comfort and
allows for more adaptation possibilities.
INFORMATION
Only authorised personnel is allowed to mount a contour
seat to the power wheelchair.
Fig. 29 Contour seat
01 / 2010 C2000