Battery Charger - Otto Bock C2000 Instructions For Use Manual

Front-wheel drive and rear-wheel drive
Table of Contents

Advertisement

Available languages

Available languages

Operation
For an optimal charging frequency the following applies:
  n The batteries can be charged at any time, regardless of 
the remaining charge.
  n It takes about 10 hours until a discharged battery (lowest 
segment in the battery symbol is flashing) is completely 
charged. Subsequently, the power wheelchair can remain 
connected to the charger without causing any problems; 
the charger has a programmed recharge phase which 
ensures that maximum battery capacity is maintained.
  n For daily use, it is recommended to connect the charger 
overnight so that the full capacity is available every day.
  n When the power wheelchair is not used for an extended 
period of time, the battery will become discharged over 
time. It is therefore necessary to charge the battery at 
least once a week to maintain full battery capacity. We 
also recommend removing the fuse when the power wheel-
chair is not going to be used for an extended period of 
time.
  n Total discharge of the batteries should be avoided.
  n When the batteries are charging, the controls on the 
power wheelchair must be switched off to allow the charg-
ing current to be fed completely into the battery.
Page 146
The following must be observed when charging the batteries:
  n Only the battery charger provided by Otto Bock may be 
used for charging. Failure to comply with this requirement 
will render the warranty null and void.
  n The voltage settings on the battery charger must corre-
spond to the voltage used in your country.
6.6.2 Battery Charger
WARNING
Explosion hazard due to sparks. Always switch off the 
battery charger and disconnect it from the power source 
before disconnecting the battery.
NOTICE
Unauthorised battery replacement. The battery may only 
be replaced by authorised specialist staff. The characteris-
tic curve of the battery charger set at the factory corresponds 
to the battery provided and must not be changed. Setting 
the characteristic curve incorrectly can result in permanent 
damage to the battery.
01 / 2010
1
C2000

Advertisement

Chapters

Table of Contents
loading

Table of Contents