Operation
3. Firmly retighten all set screws.
Fig. 12
Adapting the control panel
INFORMATION
If the control panel rail is too long, the protruding part can
be cut off with a saw.
Page 130
Changing the Control Panel's Mounting Side
INFORMATION
Only authorised personnel may change the control panel's
mounting side.
The standard configuration has the control panel mounted
on the right side. If desired by the user, it can also be
mounted on the other side of the power wheelchair.
6.1.4 Footrests
CAUTION
Risk of pinching!
Make sure your fingers are not in the danger area when
folding the footplate(s) up or down.
The C2000 can be equipped either with a narrow or wide
single-panel footrest or with two individual footrests. They are
mounted to the C2000 power wheelchair with a receiver at-
tached to rails that are already adapted in their length to the
user. For the C2000 power wheelchair version with rear-wheel
drive, only the narrow footplate is available. All footrest versions
can be folded up.
01 / 2010
C2000