Table of Contents
Advertisement
4.2.2
Adjustments
Reading Head Position
The horizontal position of the reading head must be aligned to the same position of the
printed marks on the documents. To align the reading head, proceed as follows:
1.
Open the "OMR test" menu from the "Test
menu" (refer to 2.4.6 "Supervisor Menu" on
page 16).
2.
Press
procedure.
3.
Put a document with reading marks in the
feeder (either feeder 1 or 2, depending on the
selected job).
4.
Press
The document will be transported to the reading
head position.
5.
Open the special OMR reading head cover in the
feeder.
6.
Shift the reading head until the red pointer is
positioned exactly above the middle of the
reading marks.
7.
Open the vertical transport cover and remove the document.
8.
Press
to determine the alignment.
9.
Press
to finish the alignment procedure.
Note
When the reading head is aligned it is possible that paper guides have to be removed and
placed on the other side of the reading head.
to start the alignment
.
49
Advertisement
Table of Contents
