Lexicon RV-8 User Manual page 88

Setup
CHECKING THE MICROPHONES
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
TUNER PRESETS
SETUP
Note the following:
• The RV-8 outputs calibration noise signals between 55dB and
95dB, beginning with 55dB and increasing in 5dB increments
until the microphones detect the required level. If the
calibration noise signal becomes too loud, press the
button to cancel the microphone check.
• Although the calibration noise signal is output at a fixed volume
level, you should set all volume controls for associated compo-
nents (i.e., speakers, subwoofers and power amplifiers) to a
reasonable level before performing automatic calibration.
When the procedure is finished, the RV-8 automatically reverts
to the last volume level that was selected before automatic
calibration began.
• During automatic calibration, you should refer to the on-screen
display instead of the front-panel display, as additional infor-
mation and instructions are available in the on-screen display.
1. Select the SPEAKER SETUP menu CHECK MICROPHONES option,
as shown above.
3-40
SPEAKER SETUP
SETUP
SET CROSSOVERS
INPUTS
CHECK MICROPHONES
SPEAKERS
AUTOMATIC
I/O CONFIG
MANUAL
DISPLAYS
VOLUME CONTROLS
SET CROSSOVERS
TRIGGER
BEFORE CALIBRATING
TUNER SETUP
LOCK OPTIONS
LIVE! CALIBRATION
POWER MANAGEMENT
2. The first CHECK MICROPHONES screen opens in the on-screen
display, indicating the importance of proper microphone
placement to achieve accurate automatic calibration results.
arrow
3. Press the
following screens appears in the on-screen display as the micro-
phone check is performed:
CHECKING FOR SILENCE
Appears in the on-screen display while
the RV-8 determines the relative noise
level of the listening space and the
internal noise level of the microphones.
After eliminating microphones that are
not detected or not functioning, the RV-8 calculates an average
level for all microphones.
CUSTOM SETUP CHECK MICROPHONES
GROUP MICROPHONES 40 Hz
INTO A BUNDLE IN THE 60 Hz
MIDDLE OF THE ROOM 60 Hz
60 Hz
PRESS TO BEGIN 40 Hz
MIC CHECK OFF
N/A
APART
arrow button to begin the microphone check. The
Lexicon
CUSTOM SETUP CHECK MICROPHONES
CHECKING FOR SILENCE
PLEASE WAIT