Lexicon RV-8 User Manual page 16

Basic Operation
FRONT-PANEL OVERVIEW
4 MAIN ZONE INPUT SELECTION BUTTONS
Selects the corresponding input in the Main Zone. When an input is
selected, a blue LED lights on the corresponding input selection
button. When the Main Zone is deactivated, pressing a Main Zone
input selection button activates the corresponding input in the
Main Zone. Zone 2 and Zone 3 remain deactivated until a Zone 2
or Zone 3 input is selected.
5 ZONE 2 INPUT SELECTION BUTTONS
Selects the corresponding input in Zone 2. When an input is
selected, an amber LED lights on the corresponding input selection
button. When Zone 2 is deactivated, pressing a Zone 2 input
selection button activates the corresponding input in Zone 2. The
Main Zone and Zone 3 remain deactivated until a Main Zone or
Zone 3 input is selected.
6 ZONE 3 INPUT SELECTION BUTTONS
Selects the corresponding input in Zone 3. When an input is
selected, a red LED lights on the corresponding input selection
button. When Zone 3 is deactivated, pressing a Zone 3 input
selection button activates the corresponding input in Zone 3. The
Main Zone and Zone 2 remain deactivated until a Main Zone or
Zone 2 input is selected.
7 TUNER SELECTION BUTTONS
Tuner selection buttons allow for direct entry of station frequencies,
selection of AM or FM broadcast bands and the saving/recalling of
2-4
(continued)
presets. See "Tuner Overview" on page 2-10 for additional
information.
8 STANDBY BUTTON
Toggles the RV-8 between on and standby. When the RV-8 is
powered on, pressing this button places the RV-8 into standby and
lights the red LED on the button. Power is supplied to the RV-8
when in standby. When the RV-8 is in standby, pressing the button
turns the unit on and activates all zones that were active in the
previous operating session.
In the event of a power outage, the RV-8 will display a BROWN
OUT!! PRESS STANDBY message. To turn the unit on, use the
S TA N D B Y b u t t o n . F o r m o r e i n f o r m a t i o n , s e e " P O W E R
MANAGEMENT" on page 3-3.
9 CHANNEL STATUS LEDs
Each amplifier channel has a blue LED on the front panel that is
illuminated when the unit is powered on. If there is a problem with
an amplifier channel, the corresponding LED will turn off. See
"Amplifier Overview" on page 2-13 for additional information.
10 MODE and BUTTONS
Use the Mode buttons to scroll to the previous (
available listening mode. Scrolling occurs in the order shown in the
MODE ADJUST menu. Refer to "Listening Mode Activation" on
page 6-2 for more information.
Lexicon
) or next ( )