Lexicon RV-8 User Manual page 185

8-channel audio and video control center
Hide thumbs Also See for RV-8:
Table of Contents

Advertisement

RV-8
MASTER LEVEL
Adjusts the output level of 2-channel Logic 7-encoded sources.
Available in 5.1 2-CHANNEL and DTS(-ES) 2-CHAN modes.
MID RT
Works with the SIZE parameters to adjust the amount of time
required for mid-frequency information to decay below 60dB in
level. The full parameter range might not be available depending
on the SIZE parameter setting. Available in CHURCH, CATHEDRAL
and all LIVE! modes.
CAUTION!
Setting the BASS RT, MID RT or SIZE parameters to a high
value may produce undesirable or damaging audio.
OUTPUT LEVELS
Opens the OUTPUT LEVELS menu, which is used to adjust output
levels for the Main Zone audio output connectors labeled Center,
Subwoofer, Side L/R and Rear L/R. Refer to page 5-32 for more
information. Available in all except 2-CHANNEL, MONO, 5.1
2-CHANNEL, 5.1 MONO, DTS (-ES) 2-CHAN, 2CH BYPASS and
LIVE! modes.
PANORAMA
When set to ON, Dolby PLII MUSIC and Dolby PLIIx MUSIC listening
modes extend the front stereo image to include surround channel
signals, which creates a "wraparound" effect with side wall imaging.
Available in Dolby PLII MUSIC and Dolby PLIIx MUSIC modes.
Note:
–5 to +5dB
The PANORAMA parameter within the Dolby PLII MUSIC and Dolby PLIIx
MUSIC listening modes should not be confused with the separate
PANORAMA listening mode (page 6-13).
24ms to 24.3s
PRE-DELAY
Adjusts delay time between the direct sound and the onset of rever-
beration. Higher settings make the simulated space sound larger.
Because some pre-delay is inherent in all source material, you
should begin with the parameter set to the lowest setting, then
make adjustments accordingly. Available in NIGHTCLUB, CONCERT
HALL, CHURCH, CATHEDRAL and all LIVE! modes.
RE-EQUALIZER
Simulates high-frequency rolloffs that occur in movie theaters.
When set to ON, the RV-8 applies a high-frequency filter. When set
to OFF, the RV-8 does not apply a high-frequency filter. It is recom-
mended that you set this parameter to ON for film sources, as many
films are mixed for movie theaters and might sound too bright
when played back in home theaters without re-equalization.
Available in L7 FILM, L7 TV, Dolby PLII + THX, Dolby PLIIx + THX, 5.1
L7 FILM, 5.1 L7 TV, THX ULTRA2, THX SurEX, THX, DTS (-ES) L7 FILM,
DTS(-ES) THX ULTRA2 and DTS(-ES) THX modes.
ON, OFF
REAR DLY OFFSET
Increases the perceived depth of the listening space by delaying the
arrival time of rear speaker signals. It is recommended that you
increase the setting when using side and rear speakers that are
located close together or when a greater sense of depth is desired in
the listening space. Available in all Logic 7 modes and PANORAMA
mode.
Mode Adjust
1 to 100ms, OFF
ON, OFF
OFF, 1 to 30ms
6-43

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rv-8 - rev 1

Table of Contents