Lexicon RV-8 User Manual page 131

RV-8
PERFORMING LIVE! CALIBRATION
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
TUNER PRESETS
SETUP
To perform LIVE! calibration:
1. Select SETUP LIVE! CALIBRATION as shown above.
2. The !CAUTION! HIGH AUDIO LEVELS message appears to indicate
that the RV-8 generates loud calibration noise signals during LIVE!
calibration. If the signals become too loud, press the
cancel LIVE! calibration. Press the
3. The countdown display notifies you that LIVE! calibration begins in
10 seconds. The primary reason for the 10-second delay is to give
you time to leave the listening space before automatic calibration
begins. If you choose to remain in the room, your movements
could affect the calibration results. If you leave the room, you can
return in about 3 minutes (the calibration procedure should be
completed). Press the
and begin LIVE! calibration. The RV-8 automatically activates LIVE!
calibration when the countdown ends.
When the LIVE! calibration is finished, the LIVE CALIBRATION
results screen displays one of the following two messages.
CUSTOM SETUP LIVE! CALIBRATION
SETUP
INPUTS
!CAUTION!
SPEAKERS
HIGH AUDIO LEVELS
I/O CONFIG
DISPLAYS
YOU WILL HAVE 10 SEC
VOLUME CONTROLS
TO LEAVE THE ROOM OR
TRIGGER
SIT QUIETLY
TUNER SETUP
LOCK OPTIONS
PRESS
LIVE! CALIBRATION
COUNTDOWN
POWER MANAGEMENT
button to
button to begin calibration.
arrow button to skip the countdown
LIVE! CALIBRATION
40 Hz TEST WILL BEGIN IN
60 Hz 10
60 Hz
60 Hz PRESS TO SKIP
40 Hz COUNTDOWN
OFF
N/A
APART TO BEGIN
• The CALIBRATION DONE message indicates that no errors
occurred during the calibration procedure.
• The SIGNAL TOO LOW message indicates that the micro-
phones failed to pick up sufficient calibration noise signals
for calibration to complete.
4. After reading the message, press
If the SIGNAL TOO LOW message appears:
• Examine microphone input connections to ensure that the
microphones are properly connected to the RV-8 in micro-
phone inputs 1 and 2 and that microphone cable plugs are
fully inserted for a solid connection.
• Examine the speakers and the associated amplifier to ensure
that speaker wires are connected and the amplifier is on.
• Run a Microphone Check to determine whether a microphone
has been damaged. See page 3-40 for instructions on check-
ing the microphones.
LIVE! CALIBRATION
IN PROGRESS
LIVE! CALIBRATION
CALIBRATION DONE
PLEASE WAIT
PRESS
LIVE! CALIBRATION
SIGNAL TOO LOW
PRESS
to continue.
Setup
TO CONTINUE
TO CONTINUE
3-83