Lexicon RV-8 User Manual page 235

RV-8
REPROGRAMMING THE ZONE AUDIO CODES TO DEFAULT CODES
To reprogram the RV-8 zone audio codes:
1. Simultaneously press MAIN and ENT buttons to access SETUP mode.
2. Press the P-PRO button next to the LCD screen.
3. The remote should flash SELECT BUTTON at the bottom of the
LCD screen. Press the button for the zone you wish to reprogram.
4. The remote should flash FROM TABLE at the bottom of the LCD
screen. Select the MAIN zone button.
5. The remote should flash ENTER NUMBER. The correct (default)
audio codes for the RV-8 zones are as follows: MAIN zone is 001,
ZONE 2 is 302 and ZONE 3 is 303.
6. Enter the correct code.
7. Press SAVE on the right of the LCD screen to enter and save the
audio code for the zone.
8. Exit from Preprogrammed mode by pressing the HOME button
and then exit from the SETUP mode by pressing the HOME button
once again.
Appendix C
C-17