Table of Contents
Advertisement
DC-in Jack
DC-in
This jack is considered a low power solution. Connect a DC power cord to this jack. Using a
voltage more than the recommended range (12V only) may fail to boot the system or cause
damage to the system board.
ST102-CS
Audio
MIC-in Line-out
1
9
2
10
Front
Audio
Rear Audio
The system board is equipped with 2 audio jacks.
•
Line-out Jack
This jack is used to connect a headphone or external speakers.
•
Microphone-in Jack
This jack is used to connect an external microphone.
BIOS Setting
Configure the audio settings in the Advanced menu ("Audio Configuration" submenu) of the
BIOS. Refer to Chapter 7 - BIOS for more information.
Driver Installation
Install the audio driver. Refer to Chapter 8 - Supported Software for more information.
20
www.dfi.com
Advertisement
Table of Contents
