Pentek 6230 Operating Manual page 30

Page 30
2.3 Installing the Model 6230/6231 on a VIM Baseboard
2.3.2
Standoff Screws (5)
Standoffs
VIM Panel Screws
Figure 2−8: Model 6231 with Option 102 Shipping Assembly
CAUTION
Rev.: B.4
Installing Model 6231 with Option 102
The Model 6231 with Option 102 is shipped as an assembled unit and must
be disassembled for installation on your baseboard. A separate Option 102
front panel assembly is also provided.
1) Remove both front panels from the Model 6231 VIM−2 module and the
Option 102 module by removing the two countersunk Phillips screws
from each panel (see following illustration).
(Shown with Option 102 panel removed)
2) Remove the (red) shipping brackets that hold the front panels to both
boards by removing the two pan−head Phillips shipping bracket screws
from the solder side of the Option 102 board (see illustration above).
(The shipping brackets may be discarded, or saved to store the panels if
they are removed.)
3) Remove and set aside the five pan−head Phillips standoff screws from the
top of the Option 102 board (see figure above).
4) CAREFULLY, remove the Option 102 board from the stacking connectors
(see figure above), taking care to not bend the pins.
5) GENTLY, remove and set aside both stacking connectors from the Model
6231 PCB. Do not remove the five (black) metal standoffs from this PCB.
Be careful when removing the stacking connectors, as they are fragile
Pentek Mo d el 6230/6231 Oper a ting Ma nu al
Shipping Bracket Screws (2)
VIM Panel
Shipping Brackets
and can easily be damaged.
(continued)
Stacking Connectors (2)
(Side View)