Cleaning The Camera Windows And Reflective Tape; Maintaining Ventilation - Smarttech SMART Board 8055i User Manual

C H A P T E R 7
Maintaining your interactive flat panel
Cleaning the camera windows and reflective
tape
The DViT technology in your interactive flat panel uses four cameras in the corners of the frame
and the reflective material between the screen and the bezels. Excessive dust buildup on the
camera windows or reflective tape can impair touch performance.
These areas should be inspected annually for dust and should be cleaned if any obvious dust
build-up has occurred.
C A U T I O N
Do not use compressed air to clean the camera windows or borders.
l
Do not use water, chemicals or cleaning agents.
l
g
To clean the camera windows and reflective tape
1. With a clean lint-free cloth, gently wipe the camera windows in the top corners and the
reflective tape along the top of your interactive flat panel screen using the cloth.
2. Gently wipe the reflective tape along the sides of your interactive flat panel screen.
3. Gently wipe the camera windows in the bottom corners and the reflective strip across the
bottom of your interactive flat panel screen.

Maintaining ventilation

Your interactive flat panel requires ventilation to enable the cooling fans to function. Dust buildup
in the ventilation holes compromises cooling and leads to product failure.
C A U T I O N
Avoid setting up or using your interactive flat panel in an area with excessive levels of dust,
humidity or smoke.
Clean accessible ventilation holes monthly with a dry cloth.
l
Use a vacuum cleaner with a narrow hose end fitting to clear the back ventilation holes
l
annually. You might have to remove the interactive flat panel from your wall.For more
information on removing your interactive flat panel see Removing your interactive flat panel
on the next page.
53