Disabling The Usb Port On The Side Terminal Panel - Smarttech SMART Board 8055i User Manual

C H A P T E R 3
Connecting computers and peripheral devices
g
To setup the computer 2 connection location
1. Connect a USB cable to the USB 2 port on the inside terminal panel and then run the cable
to the laptop connection location, such as beside the interactive flat panel or on a
conference table.
2. Connect a VGA video cable to the VGA 2 interactive flat panel port on the bottom terminal
panel and then run the cable to the computer 2 connection location as above.
3. Bundle and cover the cables as appropriate to avoid a trip hazard.
To connect and use a computer using this installed connection, see Connecting computer 2 on
page 46.
Disabling the USB port on the side terminal
panel
You can connect a USB drive or other USB device to the USB port on the side terminal panel of
your interactive flat panel and then access the device from computer 1.For more information, see
Using the USB port on page 42.
You can also disable this USB port so that it doesn't access any of the computers connected to
your interactive flat panel.
C A U T I O N
Disconnect the power supply for your interactive flat panel before you disable the USB port.
g
To disable the USB port
1. Locate the rectangular cut-out on the back of your interactive flat panel.
19