Smarttech SMART Board 8055i User Manual page 4

I M P O R T A N T I N F O R M A T I O N F O R Y O U R I N T E R A C T I V E F L A T P A N E L
Disconnect all power cables for your interactive flat panel from the wall socket and seek
l
assistance from qualified service personnel when any of the following occurs:
The power cable or plug is damaged
o
Liquid is spilled into the interactive flat panel
o
Objects fall into the interactive flat panel
o
The interactive flat panel is dropped
o
Structural damage such as cracking occurs
o
The interactive flat panel behaves unexpectedly when you follow operating
o
instructions
C A U T I O N
Before you clean your SMART product, shut down or disconnect the computer.
l
Otherwise, you may scramble the desktop icons or inadvertently activate applications
when you wipe the screen.
Avoid setting up and using the SMART product in an area with excessive levels of dust,
l
humidity and smoke.
Make sure that an electrical socket is near your SMART product and remains easily
l
accessible during use.
For SMART Board 8055ie-SMP interactive flat panel only: The external power supply
l
needs to meet the Limited Power Source (LPS) requirements of CSA/UL/IEC/EN 60950-
1, when required.
This SMART product should be used only with European TN and TT power distribution
l
systems.
It is not suitable for older, IT-type power distribution systems found in some European
countries. "This system (IT-type) is widely used isolated from earth, in some
installations in France, with impedance to earth, at 230/400V, and in Norway, with
voltage limiter, neutral not distributed, at 230V line-to-line." (IEC 60950:1999)
Contact qualified personnel if you're uncertain of the type of power system available
where you're installing your SMART product.
You must connect the USB cable that came with your SMART Board® interactive flat
l
panel to a computer that has a USB compliant interface and that bears the USB logo. In
addition, the USB source computer must be compliant with CSA/UL/EN 60950 and bear
the CE mark and CSA and/or UL Mark(s) for CSA/UL 60950.This is for operating safety
and to avoid damage to the SMART Board interactive flat panel.
ii