Montesa COTA 4RT RACE REPLICA Owner's Manual page 71

1
(1) WATER SEAL DRIVER
(2) DRIVER/ATTACHMENT
(1) WATER SEAL
(2) OIL SEAL
(3) BEARING
Install the water seal into the right crankcase cover in the
direction shown in the illustration above.
Tool:
Water seal driver 07945-KA30000
Install a new oil seal in the direction shown in the
illustration above.
Drive the new bearing into the right crankcase cover
(Tools; page 2-8).
2
4
(1) WASHER
(2) WATER PUMP SHAFT
(3) NEW COPPER WASHER
(4) IMPELLER
1
Install the water pump shaft, new copper washer and
impeller into the right crankcase cover.
Hold the water pump gear using a suitable tool and tighten
the impeller to the specified torque.
2
Torque: 12 N•m (1.2 kgf•m, 9 lbf•ft)
Install the washer and right crankcase cover (page 4-38).
3
1
2
3
(1) DOWEL PINS
(2) NEW O-RING
(3) WATER PUMP COVER
(1) WATER PUMP COVER
(2) BOLTS
Install the following:
– Dowel pins, new O-ring
– Water pump cover, bolts
Fill the crankcase with recommended transmission oil
(page 3-8).
Fill the coolant and bleed air (page 3-9).
Engine servicing
1
3
1
2
2
1
4-13 4-13