Electrical servicing
Checking indicator line:
Connect, when shorted, the terminals of the connector
2P (white) of the indicator relay with a jumper wire.
Connection:
Red/Black – Black
Start the engine and move the indicator switch to position
or .
Check that the indicator lights are working.
If the indicator lights are not working, check to see if
there is an open circuit in:
- Red/Black black wire
- Yellow/green wire (left side)
- Blue/red wire (right side)
- Green wires for the indicators.
If the indictor lights come on, replace the indicator
relay with one that you know is working correctly and
carry out the checks again.
6-12
6-12
(1) BRAKE LIGHT LAMP
Brake light.
If the engine starts but the brake light does not work,
check the following:
Bulb blown or not of the specified wattage.
Loose connector.
Open circuit in the Black wire between the ignition
relay and the brake switch.
1
1
(1) 2P CONNECTOR FOR THE BRAKE LIGHT SWITCH
Brake light switch.
Front:
Disconnect the connector 2P from the front brake light
switch.
There should be continuity with the brake lever applied,
and there should be none when this lever is not applied.