Montesa COTA 4RT RACE REPLICA Owner's Manual page 138

Frame servicing
1
1
(1) BRAKE HOSE CLAMPS
(2) SWINGARM PIVOT BOLT/NUT
Remove the following:
– Brake hose clamps screws
– Rear brake caliper
– Swingarm pivot bolt/nut and swingarm assembly
5-22 5-22
4
3
2
(1) DUST SEAL CAP
(2) DUST SEAL
(3) PIVOT COLLAR
(4) DUST SEAL
Disassembly
Remove the following:
– Bolts and drive chain cover
– Bolts and driven sprocket guard
– Screws and drive chain slider
– Chain tensioner
– Dust seal caps
– Dust seals
– Pivot collars
– Thrust bushings
Replace them if they have score marks, scratches,
excessive or abnormal wear.
Check the shock mounts and swingarm for stress, cracks
or other damage.
5,5 mm (0.22 in)
2
1
(1) NEEDLE BEARING
(2) DUST SEAL
(3) BUSHING
Pivot Bearing Replacement
Replace the swingarm bearings as a set.
Remove the pivot bearings using the special tool.
Tool:
Bearing driver
Press a new pivot bearing in using the special tools .
Tools:
Driver
Attachment, 24 x 26 mm 07746-0010700
Pilot, 20 mm
Face the bearing with its marked side facing out.
Press the needle bearing so that it is 5.5 mm (0.22 in)
below the swingarm end.
Install the thrust bushings and the dust seal.
3
1
2
07946-KA50000
07749-0010000
07746-0040500