Montesa COTA 4RT RACE REPLICA Owner's Manual page 115

(1) CRANKCASE BOLTS
(2) NEW SEALING WASHER/OIL DRAIN BOLT
Install the crankcase bolts.
Tighten the crankcase bolts in a crisscross pattern in 2
– 3 steps.
Install the transmission oil drain bolt with a new sealing
washer, and tighten it to the specified torque.
Torque: 22 N•m (2.2 kgf•m, 16 lbf•ft)
1
2
(1) DRIVE GEAR COLLAR
1
2
3
(1) PRIMARY DRIVE GEAR
(2) WASHER
(3) SPECIAL BOLT
Install the primary drive gear collar onto the crankshaft.
Install the primary drive gear with its groove side facing
out.
Apply oil to the primary drive gear special bolt threads and
seating surface.
Install the washer and special bolt.
1
1
(1) CLUTCH OUTER
(2) GEAR HOLDER
Temporarily install the clutch outer guide, needle bearing
and clutch outer onto the mainshaft and attach the gear
holder between the primary drive and driven gears.
Tool:
Gear holder
Tighten the primary drive gear bolt to the specified torque.
Torque: 108 N•m (11.0 kgf•m, 80 lbf•ft)
Engine servicing
2
07724-0010100
4-57 4-57