Montesa COTA 4RT RACE REPLICA Owner's Manual page 140

Frame servicing
1
2
(1) DRIVE CHAIN SLIDER
(2) SCREWS
2
(1) DRIVE CHAIN GUARD
(2) SCREWS
Install the drive chain sliders onto the swingarm.
Apply a locking agent to the drive chain slider screw
threads and tighten the screw.
Install the drive chain guard and tighten the bolts.
Torque: 0.6-0.7 N•m (0.06-0.07 kgf•m)
5-24 5-24
2
2
2
(1) PIVOT BOLT/NUT
(2) HOSE CLAMPS
Installation
Apply thin coat of grease to the swingarm pivot bolt
1
surface.
Install the swingarm into the frame.
Install the swingarm pivot bolt from the left side.
Install and tighten the swingarm pivot nut to the specified
torque.
Torque: 69 N•m (7.0 kgf•m, 51 lbf•ft)
2
Install the brake caliper onto the swingarm rail.
Install the brake hose clamps and tighten the screws.
2
1
1
(1) SHOCK ARM PLATES-TO-SWINGARM BOLT/NUT
(2) SHOCK ABSORBER LOWER MOUNTING BOLT/NUT
Install the following:
– Shock arm plates-to-swingarm bolt/nut
– Rear cushion lower mounting bolt/nut
Tighten the shock arm plate bolt.
Torque: 39 N•m (4.0 kgf•m, 29 lbf•ft)
Tighten the shock absorber lower mounting bolt to the
specified torque.
Torque: 39 N•m (4.0 kgf•m, 29 lbf•ft)
Install the rear wheel (page 5-16)
2