Montesa COTA 4RT RACE REPLICA Owner's Manual page 105

1
2
1
3
(1) BOLTS (2) IGNITION PULSE GENERATOR
(3) WIRE GUIDE (4) SOCKET BOLTS
(5) STATOR
(1) OIL PRESSURE RELIEF VALVE
Disassembly/Assembly
Remove the ignition pulse generator mounting flange
bolts and alternator wire clamp.
Remove the stator mounting socket bolts.
Remove the stator/ignition pulse generator from the left
crankcase cover.
Remove the oil pressure relief valve (page 4-1).
4
4
5
(1) SNAP RING
(3) OIL SEAL
1
(1) BEARING REMOVER
Check the crankshaft oil seal and needle bearing for wear
or damage, replace them if necessary.
Remove the snap ring and washer, then remove the oil
seal.
Remove the needle bearing using the special tools.
Tools:
Bearing remover shaft, 15 mm 07936–KC10100
Bearing remover head, 15 mm 07936–KC10200
Remover weight
2
1
3
(2) WASHER
(4) NEEDLE BEARING
1
07741–0010201
Engine servicing
1
(1) NEEDLE BEARING
Press new needle bearing into the left crankcase cover
using the special tools.
Tools:
Driver 07749–0010000
Attachment, 22 x 24 mm 07746–0010800
Pilot, 15 mm 07746–0040300
4-47 4-47