Montesa COTA 4RT RACE REPLICA Owner's Manual page 69

1
3
4
(1) LOCK NUT (2) THROTTLE CABLE
(3) THROTTLE CABLE END (4) THROTTLE DRUM
(1) SCREW
(2) INSULATOR
(3) ALIGN
Loosen the lock nut, then disconnect the throttle cable
from the throttle body.
Then disconnect the cable end from the throttle drum.
Loosen the insulator clamp screw, then remove the
insulator from the throttle body.
Installation
Install the insulator onto the throttle body while aligning
its slit with the lug on the throttle body as shown.
2
2
(1) THROTTLE CABLE END (2) THROTTLE DRUM
(3) THROTTLE CABLE
3
2
1
(1) THROTTLE DRUM COVER
(2) SCREWS
Connect the throttle cable end to the throttle drum.
Install the throttle cable to the throttle body.
Adjust the throttle grip free play.
Install the throttle drum cover and tighten the screws.
4
3
1
(4) LOCK NUT
1
2 2
Engine servicing
2
(1) THROTTLE BODY
(2) BAND SCREW
(3) 32P (BLACK) CONNECTOR
Install the throttle body into the insulator.
Make sure there are following clearance between the
throttle body:
– Throttle body-to-bank angle sensor: more than 5 mm
– Throttle body-to-silencer: more than 5 mm
Adjust the insulator band angle, tighten the band screw
securely.
Connect the ECM 32P (Black) connector.
1
3
4-11 4-11