Before You Start The Remote Ui - Canon image RUNNER 3245 Getting Started Manual

Before You Start the Remote UI

Before you start the Remote UI, perform the following:
Specify the Network Settings
Specify the settings under Network Settings in System Settings (from the Additional Functions screen)
and find out the machine's IP address. If you do not know the machine's IP address, consult your network
administrator. (See "Protocol Settings, " on p. 5-3.)
MEAP Settings
Set Use HTTP in MEAP Settings in System Settings (from the Additional Functions screen) to 'On' . (See p. 13-7.)
If you are using a default authentication, you do not need to set Use HTTP to 'On' .
Enable the Remote UI
Set Remote UI in System Settings (from the Additional Functions screen) to 'On' . It is also recommended that
Device Information Settings in System Settings is configured.
•
Connection via a proxy server is not possible. If your system environment has a proxy server, perform the following
setting. (Settings vary according to the system environment, consult your network administrator.)
- Enter the IP address of the machine into Exceptions in the web browser proxy server settings.
•
You must set your web browser to enable all cookies and use JavaScript. Otherwise, you will not be able to change
the machine's settings using the Remote UI.
•
If the control panel of the machine is being used for a particular operation, you cannot perform the same operation
using the Remote UI.
•
If multiple Remote UIs are running simultaneously, the latest setting that was made is enabled. It is recommended
that only one Remote UI be running at a time.
•
To enter characters from a web browser, use the characters that you can enter from the touch panel display of the
machine. If you use the other characters, they may not be displayed/recognized properly on the machine.
•
If you are using the login services for the MEAP function, the IP address "127.0.0.1" must be allowed, in addition to
the IP address of the computer used to start the Web browser.
•
In addition, if you are accessing IPv6 addresses, the above address must be activated.

Before You Start the Remote UI

13
13-3