lower mounting bolt hole and joint pin hole is 83±1mm.After
adjustment,tighten the joint nut.
Carburetor/ Engine Idle RPM Adjustment
If the engine idle speed is not satisfactory, and all other
conditions are favorable, the carburetor can be adjusted as
follows:
1. Warm up the engine by running the
vehicle approximately five minutes.
2. Place the transmission in gear with
the parking brake applied.
3. Adjust the carburetor idle screw in
or out until the desired idle RPM is
reached. Turning the screw in
(clockwise) will raise RPM. Turning
the screw out (counterclockwise) will lower RPM.
4. The standard idle RPM is 1500±10%(for 300cc)
16. MAINTENANCE
Throttle Cable Free Play Adjustment
Throttle cable free play is adjusted at the handlebar.
OWNER'S/OPERATOR'S MANUAL
ATV300-D T3b
- 99 -
16.0