Setting Up A Master/Slave Configuration - EdgeWave iPrism Web Security Administration Manual

iPrism

Setting Up a Master/Slave Configuration

There are two steps to setting up a master/slave configuration, and it is recommended that they be
completed in order:
Designating Slave
1.
Designating the Master
2.
Designating Slave Systems
For each iPrism that will be a slave:
• There must be a valid DNS configured.
• Co-management must be enabled.
• The co-management IP address range must include the IP address of the master
To set up slave:
From the iPrism home page, select System Settings, then Central Management.
1.
Select Slave from the iPrism Mode dropdown list.
2.
Click Yes to confirm.
3.
If the password has not already been set, click Set Password and enter the password to be
4.
used. This password must be the same for all iPrisms that are included in the Central
Management configuration.
If you want to designate another iPrism as a slave, click Logout, then log into the iPrism you want to
designate as a slave and repeat these steps.
Chapter 9 Central Management
Systems.
System.
Administration Guide
152