Recovery - EdgeWave iPrism Web Security Administration Manual

iPrism
Select which interfaces are in use when the iPrism is in a failed state. The recommendations for
6.
these settings are the same as for standby. The internal and external interfaces can be enabled
immediately, after a brief time delay, or not at all. If a time delay is chosen, the interface will be
shut down for this time period when the iPrism fails, and then iPrism will attempt to turn the
interface back on.
Click Save to save your settings.
7.
If you have completed all your administrative changes, click Activate Changes to activate the
8.
changes immediately. If you do not Activate Changes now, you will be prompted to do so before
logging out of iPrism.

Recovery

If an iPrism set up for HA fails, a new button, Recover, appears in the HA window.
To recover the iPrism:
Click Recover.
1.
The iPrism comes back up (if the problem has been fixed) in standby mode. Leave it in this mode
for several minutes so that it can complete its self checks. If this iPrism is configured as the pri-
mary, after the self-check is completed, a new button, Take Control, appears.
If you want the primary iPrism to become the active iPrism, click Take Control. If the iPrism is
2.
working properly, it becomes active and the other iPrism goes on standby.
Chapter 7 System Settings
Figure 72. Standby and Failed State Settings
Administration Guide
116