Page 3
Contents ERS Hardware ........................4 Front and Back Covers..................... 4 LEDs and Lights ....................... 5 Power Supplies ........................ 6 Installing the ERS M6200 Appliance ................6 Contacting St. Bernard Software Technical Support ............. 7 ERS Hardware Guide...
Page 4
ERS Hardware Front and Back Covers Figure 1: ERS M6200 with cover installed Figure 2: ERS M6200 Front Panel (with cover removed) ERS Hardware Guide...
Page 5
LEDs and Lights • Ethernet Interface #1/#2 Activity Light: Blinking green indicates that data is passing through the management interface. Steady green indicates the management interface is connected. • On/Off Switch: When power is not applied to the system, press this switch to power the ERS appliance.
Page 6
• Ethernet Interface #1: This RJ45 connector provides auto-sensing Gigabit Ethernet connectivity to your local network. • Ethernet Interface #2: This RJ45 connector provides auto-sensing Gigabit Ethernet connectivity to your local network. Not normally used. • Power Supply LED: Indicates that the individual power supply is turned on and operational.
Page 7
Contacting St. Bernard Software Technical Support Phone and email support: Weekdays, 12:00 Midnight – 4:00 p.m. Pacific Time (8:00 a.m. to 12:00 Midnight GMT) To contact Technical Support online, visit http://www.stbernard.com/products/support/iprism/support_iprism-6-0.asp and fill out the Support Request Form. iPrism Phone Numbers: Tel: 1-858-676-5050 Fax: 1-858-676-5055 Chat support:...
Need help?
Do you have a question about the iPrism ERS and is the answer not in the manual?
Questions and answers