ATTACHING THE AIR PURIFYING FILTERS
CAUTION
!
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
1
Open the front panel
Pull up the front panel by holding it at both sides
●
with both hands.
2
Remove the Pre-fi lter
●
Push upward to release the claws and pull out the
Pre-fi lter.
3
Attaching the air purifying fi lters
Attach the air purifying fi lters to the frame by gently
●
compress its both sides and release after insertion
into Pre-fi lter frame.
CAUTION
!
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Please do not smell direct from
source of fi lter.
4
Attach the Pre-fi lters
Attach the Pre-fi lters by ensuring that the surface
●
written "FRONT" is facing front.
After attaching the Pre-fi lters, push the front panel at
●
three arrow portions as shown in fi gure and close it.
NOTE
In case of removing the air purifying fi lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
●
purifying fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
●
Air purifying fi lters are not washable. It is recommended to use vacuum to clean it. It can be use
for 1 year time. Type number for this air purifying fi lter is <SPX-CFH22>. Please use this number
for ordering when you want to renew it.
Do not operate the air conditioner without Pre-fi lter. Dust may enter the air conditioner and fault
●
may occur.
– 18 –