Assemble The Starter Motor (7) - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

5
6
8
12
11
7
11
Ed. 07-2010
ENGINE REASSEMBLY
Refit the rotor (5). Hold the rotor (5) to prevent rotation and place an aluminium
shim or dummy gear between the primary drives gears on the right side, again
to prevent rotation. Tighten the nut (6) to 75 Nm, 7.5 Kgm, 54.3 ft/lb. Use a 17
mm wrench.
Before installing the starter motor (7), check for free (clockwise) rotation of the
freewheel (4) while holding the rotor (5) steady.
7
H02248

Assemble the starter motor (7).

TE-TXCi
place it if needed. Make sure to position it correctly with the gasket hole
(9) matching the hole (10) in the starter motor flange.
9
10
H02249
Fit the starter motor (7) into place.
TE-TXCi
Tighten the bevel drive screws (11) using a 4 mm Allen wrench (6 Nm - 0.6Kgm
- 4.43 ft/lb).
Tighten the screws (12) (12a) using a 4 mm Allen wrench (6 Nm - 0.6Kgm - 4.43
ft/lb).
12=L= 25 mm
12a=L=30 mm
12a
H02250
WARNING: On assembly, check the gasket (8) for damage and re-
H.39