Sprocket Installation - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

ENGINE REASSEMBLY

Sprocket installation

Install the oil seal retaining plate (1) and tighten the screws (2) (use an 8 mm
wrench , 5.5 Nm, 0.55 Kgm, 4 ft/lb).
Fit the spacer (3) with the grooved side facing inwards.
Install sprocket (4), lock washer (5) and nut (6). Hold the sprocket (4) with the
suitable tool (7) to prevent rotation and tighten the nut (6) (use a 22 mm wrench,
100 Nm, 10 Kgm, 72.5 ft/lb).
Bend the tabs of the lock washer.
Ed. 07-2010 H.37