Electronic Control Unit (5) And Voltage Regulator (6) Position (Te - Txci); Securing The Starter Motor/Solenoid Starter Cable (Te - Txci); Battery Negative Cable Routing (Te - Txci) - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

ELECTRICAL SYSTEM
• Electronic control unit (5) and voltage regulator (6) position
(TE - TXCi).
Electronic control unit installed with the flat side down.
Voltage regulator installed over the electronic control unit.
Coat voltage regulator with heat grease.

• Securing the starter motor/solenoid starter cable (TE - TXCi)

Connect the starter motor/solenoid starter cable (7) as shown in the figure.
• Securing the engine ground to chassis and engine ground to battery
cables (8) (TE - TXCi)
The engine ground to chassis and engine ground to battery cables are secured
to the timing chain tensioner screw.

• Battery negative cable routing (TE - TXCi)

Routing of engine ground to battery negative cable (8).
8
H00924
Ed. 07-2010 M.45