Piston Ring Installation; Piston And Cylinder Installation - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

Hide thumbs Also See for TE 250 - 310 2011 I.E.:
Table of Contents

Advertisement

ENGINE REASSEMBLY

Piston ring installation

Fit the piston rings as shown in the diagram. If the piston ring is marked on one
side, that side must be facing up.
A= Compression ring
C= Oil control ring
*C1= Top oil rail end gap position
*C1= Oil rail spacer end gap position
*C1= Bottom oil rail end gap position

Piston and cylinder installation

Remove the rubber protection (1).
Install a new cylinder foot gasket (2).
Assemble piston (3) to connecting rod (4) (lubricate with engine oil) and fit the
piston pin retaining rings (5).
Make sure the arrow mark on the piston is pointing to the front end.
Make sure that the locating pins (6) are in place.
H.40
Ed. 07-2010

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tc 250 2011Tc 250i 2011 i.e. usa

Table of Contents