Husqvarna TE 250 - 310 2011 I.E. Workshop Manual page 71

TC
2
Ed. 07-2010
GENERAL PROCEDURES
-
-
-
-
3
H02206
-
Remove the saddle as described in the relevant paragraph.
Remove the left-hand side panel as described in the relevant paragraph.
Using an 8 mm T-wrench on the outside and a 10 mm T-wrench on the inside,
remove the silencer (4) retaining screw (1).
Remove the spring (2) (TC) and the screw (3) using an 8 mm T-wrench; slide
out the silencer (4).
TE-TXCi
3
Disconnect the Lambda sensor connector (7) and shear the wiring clips (TE-
TXCi).
E.9
H02207