Relay Test (Te - Txci) - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

ELECTRICAL SYSTEM

Relay test (TE - TXCi)

Remove saddle and fuel tank as described in "Section E". Remove the relays
(1) located on the R.H. side of the chassis.
A: Set the meter to the "Impedance" scale and check the energiser coil for
proper operation. Reading should be: 80 Ohm (+/- 10%) at 20 °C.
B: Set the meter to "Continuity" mode and check the circuit is open.
C: Feed the coil from a power supply unit with stable 12V output and make
sure that the circuit closes.
M.34 Ed. 07-2010